Ositech comm Trumpcard Data/Fax Modem Manual de usuario descargar pdf (Pagina 59)

User’s Guide and Reference 4 - 27

Modem Command Reference

&Zn=x — Store Phone Number

Parameters n = 0, 1, 2, or 3, x = dial string

Default none

Stores a 36-digit dial string (x) in the specified entry (n) for later dialling.

(See DSn command.)

\Bn — Transmit Break

Parameters 1 through 9 (If n = 0, the default value is used; if n is

greater than 9, 9 is used.)

Default 3

When this command is entered during a non-error correction connection,

the modem sends a break signal to the remote modem. The length of the

break is 100 times the n parameter value in milliseconds. If this command

is entered during an error-correcting connection, the break will be sent via

the error-correcting protocol giving no indication of length.

Result Codes

NO CARRIER If not connected

\Gn — Modem-to-Modem Flow Control

Parameters 0 or 1

Default 0

The command applies in non-error correction mode; the modem enables

or disables the generation or recognition of modem-to-modem XON/XOFF

flow control.

Examples

AT\G0 Disables modem-to-modem flow control

AT\G1 Enables modem-to-modem flow control

\Kn — Break Control

Parameters 0 through 5 (If n is greater than 5, 5 is used.)

Default 5

Determines what the modem will do when a BREAK is received from the

communications software or the remote modem. During error correction

mode, the remote modem's BREAK control setting determines how the

local modem will handle the BREAK.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 85 86

Sin comentarios

Ositech comm Trumpcard Data/Fax Modem Manual de usuario Pagina 59